how to fix a flooded lawnmower engine?

how to fix a flooded lawnmower

fix a flooded lawnmower

Lawnmowers are important to home appliances; they make the entire ordeal of cutting grass inherently easier. Most of the time, they work perfectly; you mow the lawn, and in a couple of minutes, you’re pushing it back to the garage or store till the next time you think your lawn needs a trim. However, that doesn’t mean lawn mowers are immune to breakdowns and those rare instances when they fail to run well, or even start at all. One such circumstance is when your mower engine gets flooded, and it fails to start. Before you know how to fix a flooded lawnmower, you’re left debating on what to do to get it up and running again.

so, the best way to fix a flooded lawnmower engine-

There are a couple of ways which you can employ in order to fix a flooded lawnmower engine. If you know what to do, it won’t be long until you get it up and running again, so it’s good to know your stuff.

Here’s what you do:

Leave it to rest on a level ground for up to 20 minutes :

this is by far the easiest and the best way to do it. As a matter of fact, most manufacturers advice that you do this for most of their models. You see, when the engine gets flooded, the [easyazon_link identifier=”B006E1EE88″ locale=”US” tag=”lawnmowergarden001-20″]carburetor[/easyazon_link] fills up with too much gasoline. Therefore, leaving it to rest on a level ground allows the gasoline to drain, hence reinstating the mower to initial condition of operation.

If patience isn’t your strong suit, then removing the air filter and the spark plug will also do it: doing so has two major outcomes. First, this creates an air passage, which allows for evaporation to take place at a faster pace in the carburetor. Secondly, removing the spark plug ventilates the combustion chamber. Only after 5 minutes have passed are you then allowed to replace the plug back.

Tips to avoid a flooded lawn mower engine:

They say prevention is better than cure, and the same thing applies to a lawnmower. There are things and certain practices you can take up to ideally prevent it from being flooded in the first place. In the case of a long period of storage, it is advisable to change the old fuel with fresh fuel. This is because, storing your mower with the same fuel for long causes it to mix with moisture, which is a direct cause of it flooding. Replace worn out, corroded or spoil [easyazon_link identifier=”B00L3XGGJ2″ locale=”US” tag=”lawnmowergarden001-20″]spark plugs[/easyazon_link] with new  ones :

just like in the first case, leaving the spark plug in place for long can cause it to wear out, and that can cause the engine to flood as well. Replacing it with a new one is the way to go.

Conclusively, never over-prime your carburetor before you pull on [easyazon_link identifier=”B017EWZJ0M” locale=”US” tag=”lawnmowergarden001-20″]the starting cord.[/easyazon_link] That’s just another way to get your lawn mower engine flooded.